PLD UoMs

[Former Member]

Hello

I apologise if this question has been asked before as it seems an obvious one, but I have been unable to find the asnwer.

We are creating documents in PLD and would like to be able to set width, height etc settings in millimeters rather than pixels. Where can this setting be made?

Thank you.

Regards

[Former Member · Accepted solution]

Hi,

PLD has only one UoM which is pixel. If you would like to get number to corresponding mm, check the paper size under Document Property of PLD. Simply divide the total pixels of total width/height by actual mm for paper, you will get the ratio.

Thanks,

Gordon