Skip to Content
avatar image
Former Member

Defect recording for inspection points

Hi,

My client having requirement of recording the defects every hour.in standard SAP defects recording with respect to inspection point is not possible.Is there any other way to do this.

Regards,

S.P.Selvathangam

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • avatar image
    Former Member
    Sep 04, 2008 at 10:11 AM

    Hi,

    It is not a problem follow the below step.

    1). Go QM01 enter notification type Q3 (Manual Defect and Notification creation) and press enter.

    2). After enter system will raise the one pop up screen here enter the production order as well as operation number and press enter.

    3), After that it will open defect with notification screen here you can enter defect qty, defect code reason, causes etc and save.

    For any query revert.

    Thanks & Regards,

    S.Babusingh

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Sep 04, 2008 at 10:40 AM

    hi you can recorder defects from QM01, use the notifiaction type and then you can record your respective department defects,

    Q1 Customer Complaint

    Q2 Complaint ag. vendor

    Q3 InternalProbNotif.

    if you want to capture some defect related operations an cost you can crete the QM order frrom notification.

    - pl check

    ashok

    Edited by: ASHOK on Sep 4, 2008 4:11 PM

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Hi Selva

      If you want to record the defect ,when the value of MIC is Off spec while RR. - you can choose the automatic defect recording

      it is not the case --

      you want only record the defects? Not RR .....

      Sami