Status 51 Error in ALE IDOC

[Former Member]

Hi,

Iam trying to send a MATMAS Idoc from one client to another client , which is in the same R/3. The outbound staus is 03 and the inbound is 51.

I just created a material (Material details are attached below for reference) and send tht material to the other client using BD10.

can you please tell me the Inbound function module name which i should use to post it again.

Material Name:KRMATERIAL

Industry sector : Mechanical Engineering

Material Type : Finished Products.

Base unit of measure as KG.

Gross Weight as 200.

Net Weight as 100.

Weight Unit as KG.

Thanks

-Karthik

[former_member195698 · Accepted solution]

You can resend the Idoc from your sender system through BD10. after correcting the earlier issue.

Regards,

Abhishek

[Former Member · Accepted solution]

Hi,

I would like to process tht IDoc in the Inbound side , if you go to WE19 , their will be a Inbound Function module to process the message again for STATUS -51,

so i need the INBOUND function module name for MATMAS

[former_member195698 · Accepted solution]

Check it through WE57 (FM,Idoc type Message type) and WE42 (Process code, FM, Message type)

It will be IDOC_INPUT_MATMAS01 or IDOC_INPUT_MATMAS_MDM based on the Basic Type.

Regards,

Abhishek