In this blog series, I would like to describe a few standalone enhancements in more detail, which can be very helpful in unique situations and can be used independently from the requirements to deploy process from Focused Build.
In this six-part, I ...
In this blog series, I would like to describe a few standalone enhancements in more detail, which can be very helpful in special situations and can be used independently from the requirements to deploy process from Focused Build.
In this fifth part,...
In this blog series, I would like to describe a few standalone enhancements in more detail, which can be very helpful in unique situations and can be used independently from the requirements to deploy process from Focused Build.
In this fourth part,...
In this blog series, I would like to describe a few standalone enhancements in more detail, which can be very helpful in special situations and can be used independently from the requirements to deploy process from Focused Build.
In this third part,...
In this blog series, I would like to describe a few standalone enhancements in more detail, which can be very helpful in special situations and can be used independently from the requirements to deploy process from Focused Build.
In this second part...
We can use automatic XLD then the transport request is created in the same change document then the source transport. But it does require that both landscapes are in the same change cycle.The wizard does not support automatic creation of transports.
Wizard based distribution can only distribute 2 one target after each other...you would need to finish it for one target and then start the wizard again for the next target. Thats by design because in the wizard you can only select one target CD/Tran...
@oladayo16 sorry for the late response, i somehow missed your request, but yes for Urgent Change you can't use Automated XLD on the same change document because a urgent change always only have the systems from the direct transport track in its task ...
Hi , i would need a little bit more description on where you try to select additional target systems ! If you are using strict mode target systems are defined in the distribution group and there they need to be typed so i'm not sure where you expect ...
Hello Imran,
your scenario is probably better solved with CutOver Checks and Activities see https://blogs.sap.com/2018/09/19/cut-over-checks-activities-focused-build-standalone-extensions-part-6/
Repack can only Repack Transports within the same sy...