Pipe line steps ? Same for All Scenario's ? Not Same?

[Former Member]

Hi All

My question is Pipe line steps are constant for all the scenario's

Irrespective of sender and receiver ?

Or For some scenario's will it differ? like BPM, Proxies ....?

Can any one help me on this pl.....

Anv...thanks and points to helpful answers

kiran LVS

[Former Member · Accepted solution]

all messages as pass thorugh pipe line steps .If it BPM then it gives BPM engine but this is done again through IS .

[Former Member · Accepted solution]

Hi

All messages in 'IS' will follow the same steps irrespective of sender/receiver

And the steps details are as follows

1. Receiver Determination--> Determine the receiver of the message using the Sender Service, Sender Interface and sender namespace.

2. Message Split --> if multiple receivers are found, split of the message for each receiver.

3 Interface determination --> Determine the inbound interface and the interface mapping for each of the receivers.

4 Message Mapping --> Execution of the mapping program!

5. Technical Routing -> The messages in mapped to the corresponding target Transport Protocol

6. Call Adapter --> The target adapter is called and the message is passed to the same.

Regards

--- prasad