on 06-03-2013 1:04 PM
Hi all,
Can someone please guide me, I've created an RFC connection in ABAP backend system to connect to PI system and when i do connection test it bring a pop to enter username and password.
In PI user PIAPPLUSER has roles SAP_BC_WEBSERVICE_PI_CFG_SRV and SAP_XI_APPL_SERV_USER. Also password in SM59 rfc is same in both PI's AS ABAP and exchangeProfile url. Please note the problem is in our QA ystem, in development it's working and i can do SPROXY without any problems.
I tried with both XI and xi in path prefix : /sap/XI/engine/?type=entry
Thank you and regards,
Katlego
Hello,
Usually this happens when there are two RFC destinations pointing to your XI system e.g
1. Check in sxmb_adm -> integration engine configuration to see which rfc destination you are using. It should be dest://NAME_OF_RFC_DESTINATION
2. Check SM59 type H if that rfc destination exists
3. Check SM59 type G if SAP_PROXY_ESR exists
Please take note that only one needs to exist and not both. Just delete SAP_PROXY_ESR if a type H destination is already pointing to your XI system.
Hope this helps,
Mark
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Mark,
At first I only had rfc connection of type H but with that I was getting an error when running SPROXY but after defining SAP_PROXY_ESR I can now run SPROXY. I've now deleted type H rfc connection and when i run the proxy function module I get error INTERNAL.DESTINATION_NOT_FOUND HTTP destination does not exist and this is becuase in SXMB_ADM I still had the old type H connection defined. Even after I changed it to type G rfc, the proxy function is still giving an error refereing to the old one.
In SXMB_ADM, with rfc type H i could doubleclick on the dest://RFC_CONNECTION it will take me to the rfc connection but with type G i get Function code cannot be selected.
Our PI system is 7.11
Thank you and regards,
Katlego
Hi Mark,
I've deleted type G rfc and recreated type H connection. I've also updated rfc destination in SXMB_ADM. Both rfc connection test and proxy function module still bring popup to enter username and password.
That error in SPROXY is now gone, but previously it was gving same that popup to enter username and password and then that message(i forgot the details) where it says use the SPROX_CHECK* programs to diagnose the error. I've ran all 4 again now and they all successfull.
Also we've separate FI and HR systems, so from our FI QA systems the rfc connection test with the same user PIAPPLUSER is successfull system but not in HR QA. Both development systems are working fine.
Thank you and regards,
Katlego
Hi Mark,
I finally got it, the PIAPPLUSER's password must all be in uppercase. This i got it from the link http://scn.sap.com/thread/1636753 . The other difference is our FI systems is ECC6 and HR ECC5 hence it I had no problems in FI.
Thanks a lot for your help.
Regards,
Katlego
User | Count |
---|---|
83 | |
11 | |
10 | |
8 | |
7 | |
7 | |
6 | |
6 | |
5 | |
5 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.