WMS with Quality Management

[Former Member]

Hi Experts,

I am certified MM Consultant, but I am new to WMS since I have not taken any training in WMS. We have to implement WMS in one of our plant with QM. I have some doubts in WMS. Requested to help me.

I have posted one migo (mov type 101) of one quality activated material qty 100 nos. in WM screen Wrehouse No . XXX, St Type 902, St Bin 4500000220. (4500000220 is a PO number). TR No. xx. Automatic TO Ticked in Config. But there is no TO created/ confirmed in the sytem in T-Code LT23.

Now I gave UD using T-code QA32, 90 Nos Approved and 10 Nos Approved. WM Screen as follows in the material document.

mov type 321, Qty-90 Nos, st type 922, St Bin -TR-ZONE, St category Q, Posting change No. 4,

mov type 309, Qty-10 Nos, st type 922, mov type 309, St Bin -TR-ZONE, st category S, Posting change No. 5,

Please check the steps, confirm me what is missing in spro and futher steps to putaway the material in bins, putaway st- next empty bin. Incase any further information, pl revert.

Regards

Ishu

[Former Member · Accepted solution]

Follow the following steps,

1. If TO creation failed during posting GR, please create TO using LT06 for material document created against PO.

2. With above TO creation, move material from 902 4500000220 to another Stype say 800

Confirm the TO created. Stock will in in Q staus.

3. As Sandi told, create TO's against 2 PCN's after posting UD.

4. The first TO created against PCN for 90 Qty will converts material from Q to UR.

5. The second TO created against PCN for 10 qty will converts material from Q to BLOCKED.

6. Confirm the TO's created at step 4 and step 5.