Customize the error/warning message during purchasing because of quality reasons

[Expert]

Hello Experts,

With the Quality Info record created for the Material-Plant-Vendor combination and set for, the following system pop-up appears: 

Release qty. restriction -  application 06, message no. 880  

Vendor Block -  application 06 , message no. 883  

With QM master data - QM Control key maintained for 9001, ERROR message appears with msg no. 883 - .  "Procurement of material & blocked for quality reasons"; 

For QM Control key set for 0001,  WARNING message appears for supplier block as well as the quantity restrictions at the time of purchase order creation. Error message is required by the client at this step.  

The configuration under the Sourcing and Procurement for Purchase order processing - has options to configure the System messages. But this is not allowing to change the E(Error) or the W(Warning) message for the quality-procurement interface messages. 

 Is there a possibility to customize the warning to error messages?

[Expert · Accepted solution]

Hello!

Unfortunately, It is not possible to change the standard logic(warning to error messages). --Currently, there is no SSCUI to define the QM control Key. In the standard design, the message mode for Control Key 0001 is Warning and the message mode for Control Key 9001 is Error. It cannot be changed in standard logic.

If it is critical I would request you to open request at SAP Customer Influence(http://influence.sap.com/saps4hanacloud )