Calibration process

[vivek_varun2]

Hi all,

For calibration process,  I have assigned inspection type 14 to  order type  and  assigned inspection point 300 in task list. but still inspection lot  is not originated from maintenance order. In previous orders inspection lot is originated but ,its not originating now.

What could be reason for it.

Thanks

Vivek Varun

[jogeswararao_kavala · Accepted solution]

What about behavior in other clients Dev and Quality. If it is same then Try this

In customizing, remove Inspection type 14 against the Order type and Save. Now put it again and Save. See what happens? IF it resolves then transport this to PRD.