12-07-2017 2:41 AM
Hi Expert,
I create a AMDP procedure for ABAP CDS table, and try to do debugging, but when I try to create a break-point in AMDP code, there is error displaying as below. I try everywhere in the code, error happens all the time.
12-08-2017 4:04 PM
12-07-2017 1:03 PM
Did you install the debugger perspective are you tring to debug in ADT or SAP GUI ??
12-07-2017 4:32 PM
I am doing AMDP procedure for ABAP CDS table, all works are on ADT, and also debugger perpective installed, and also I can perform debugging well for non-AMDP programs, but for all AMDP procedure, I get the same error message for setting break-point. but for other AMDP procedure, I get following error:
12-08-2017 7:43 AM
https://blogs.sap.com/2014/01/31/tutorial-how-to-debug-an-abap-managed-database-procedure/
I think you need to use external debugger
12-08-2017 3:34 PM
unfortunately , I don't have access for sap hana modeler or development persfective, so I can't access hana procedure. I think external debugger should work, but I still want to know why I can't not use new debug approach as my system is above 7.5.
12-08-2017 4:04 PM
12-08-2017 7:39 PM
Hi Mike, I can set breakpoint for non-AMDP code, also I create another AMDP procedure, where breakpoints can be set,
12-09-2017 8:33 PM
OK, if it works for some but not this method that is strange.
My point was that you set a breakpoint before the procedure call for two reasons:
1. to fulfil your goal - to debug the procedure!
2. to verify whether you can actually debug it. If not, then trying to step into it may give you a clue what the problem is.
12-08-2017 4:11 PM
Integrated AMDP debugging is available from AS ABAP 7.50 on.
How to do this before can be found here https://blogs.sap.com/2014/01/31/tutorial-how-to-debug-an-abap-managed-database-procedure/
And I found it by searching ...
12-08-2017 7:34 PM
Hi Horst, I can use this integrated AMDP debugging before, but can't do it right now for this code, but I create other AMDP, breakpoing can be set.