CK11N uses planned price in PPC1 and not in PPC3

[Former Member]

Dear All,

When I execute CK11N with PPC1 costing variant it takes the planned price for the semifinished goods for which an error occurs.

When I execute it with PPC3 it doesn't throw errors and it also still calculates the price from the subcomponents and doesn't take the planned price.

Where is this set in the costing variants definition, I don't see any customizing possiblilities for it. Is it because PPC1 is allowed to update standard price?

Best regards,

Michaë

[former_member184655 · Accepted solution]

Dear Michael,

1.This is more of CO settings,i would suggest you to get the relevant info from your CO consultant.

2..FYI purpose ,Goto OKKN and check for the costing variant PPC1 --->valuation variant and the necessary settings.

3.Similarly also check for PPC3,which is a current cost estimate.

4.CK11N may be executed with various costing variant,but ultimately it should be with a standard cost estimate(costing variant)

saved without error and marked and released using CK24.

5.Rectify the errors displayed when you execute CK11N with PPC1 and then proceed.

Regards

S Mangalraj

[Former Member]

Trough OKKN you can customize or check the Costing Variant. The differences between PPC1 & PPC3 , if both variants have been maintained as standards, is that Valuation Variants (e.g. define where the material prices come from) are different. Verify this in your system,