on 09-21-2010 3:27 PM
Hi All
I am facing an issue during Usage Decision for an Inspection Lot Created thru Callibration Order. While declaring the UD for the said Lot as rejected and after saving the same there appears a pop up suggesting for Object status to be change . My issue is the pop up screen appears blank means there is no Tech Object in that . I have checked the configuration which is in place but still the issue is coming . Following are the config settings :
1 The recjection code is assigned with the followup action object
2 The equipment in question is with equioment category - P and the PRT data exists for the same
3 Config for Automatic Followup action is in place
QFOA_OBJECT_STATUS_SET
Follow-Up Action: Set Equipment Status/Change Cycle Modification Factor (Both ticked)
Pls confirm whether something more is required to be set to get rid of the issue
Regards
Manoj
Hi Manoj...
Hope you are doing well
Can you pass what exactly solution you sorted out
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Manoj,
Can you please share the solution that you got. It will be helpful for the forum users.
Praveen
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Issue Resolved
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
97 | |
9 | |
8 | |
6 | |
3 | |
3 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.