on 09-07-2010 2:03 AM
Hi all,
I have a requirement to limit the value of certain surcharges per line item .(to 75$/ton)
material1
(variant)
VA00 surcharge1 60$/ton
VA00 surcharge2 80$/ton
VA00 surcharge3 90$/ton
VA00 surcharge1 and VA00 surcharge2 belongs to ZTable entries (VA00 surcharge3 does not belong to Ztable)and are subjected to surcharge limit.I am planning to put a discount type to negate the surcharge.The total value of VA00 surcharge1 and VA00 surcharge2 is 140 $/ton.It should be limited to 75$/ton
VA00 surcharge1 60$/ton
VA00 surcharge2 80$/ton
VA00 surcharge3 90$/ton
xyz(surcharge limiting discount condition type) --65$/ton (140-65 =75$/ton)
( so that a total of 75$/ton applies to material for surcharges VA00 surcharge1 and VA00 surcharge2 since it belongs to Ztable)
What is the best way to have negative value for XYZ discount type to negate surcharge value? ( alternate calculation type?alternate condition base value?) Pls advise
regards
jill
Make new condition XYZ = from line 1 to 2
set upper limit 75 in config "Define upper/lower limits for conditions" in "Define Condition Type".
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
99 | |
9 | |
8 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.