standard report for list of reversed measurement document

[stheurkar]

Dear All,

Is there any standard report available where we can see a list of reversed measurement document for a particular measuring point. I have checked IK17 report, but in that i am not able to see reversed measurement document for particular measuring point.

This is required if i want to reset the reversed measurement documents after some days then for that i need a list of reversed document list. With ref. of this list i can reset the documents.

Eagerly waiting for your favorable response.

Thanks & Regards,

Sandeep

[jogeswararao_kavala · Accepted solution]

In the IK17 selection screen itself, select the radio button 'with' against the Reversal Indicator field (at the bottom of first section) and Execute.

Regards

Jogeswara Rao

[Former Member · Accepted solution]

Hi

you can check in the same tcode as ik17 no need for special report or custom report

in the tcode IK17

Select the measuring points in the measuring docuemnt selection select Revesal indiactor button with & execute

you can take it in excel also

Regards

pratap

[stheurkar · Accepted solution]

Hi Pratap / Jogeswara

Ohhh.....Yes...Thanks for responding.

Still i have one query regarding reversal of measurement document, is it mandatory to 1st create a substitute measurement document for which we are going to reverse the measurement document.

or

Can we 1st reverse the measurement document and then we can create substitute document for the same.

I am not very clear about which step from above i have to follow while reversing the measurement document. Is this affecting recalculation of measurement document.

Thanks & Regards,

Sandeep

[jogeswararao_kavala · Accepted solution]

If the measuring point is a counter the cumulative reading is reduced by that much value as that of reversed document

As was told earlier the report comes as per your selection of Reversal Indicator (with, w/o, with or w/o)

In otherwords for all practical purposes the reversed reading is omitted.

Regards

Jogeswara rao

[jogeswararao_kavala · Accepted solution]

For the first question the answer is - It is not manadatory.

Then, If the measuring point is a counter the cumulative reading is reduced by that much value as that of reversed document

As was told earlier the report comes as per your selection of Reversal Indicator (with, w/o, with or w/o)

In otherwords for all practical purposes the reversed reading is omitted.

Regards

Jogeswara rao