activating defect class during result recording.

[Former Member]

Hello Friends

I have created Defect class with few codes, during result recording defect class is 'GREY' not allowing to select code (only display).

I want it's should be available so that one can choose the relevant code from defect class whille doing result recording.

Kindly provide your expertise comments to do the same.

Regards

Swanad

[former_member186399 · Accepted solution]

Dear Swanad

Please do the following setting

In Result recording screen > Go to Setting (Menu button ) > Defect Class on

By doing this when you do result recording and the reading is out of spec then after the valuation pop up defect class will get popped up. You can select any one of the defect class

Regards

Gajesh

[Former Member · Accepted solution]

Thanks, Actually i am looking for some setting globally (for all inspection lot)so that there is no need to go in setting and do defect class on for every inspection lot.

Kindly reply back.

Regards

Swanad

[former_member186399]

Dear Swanad

I think it is global setting

Please check, if you do setting once it is set for all inspection lot. you may check with doing result recording for another lot

Regards

Gajesh

[Former Member]

Hi

i tested, yes it's global setting, once defect class is on, it's applicable for all inspection lot henceforth.

Thanks

Swanand