Skip to Content

Purchase Order Message Output Logical Destination

I've set at MN05 for my POrg / Doc Type / PGrp. with logical destination LOCL

Output type ZEPO

When i raised a new PO, it is picking up correctly. Then i'll save the PO

Next day, i will want to reprint the PO. I will go to Messages > manually write ZEPO.

However when i check inside Communication Method, the LOCL isnt populated

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • avatar image
    Former Member
    Nov 21, 2016 at 09:56 AM

    Just confued with your question,

    If you have printed one time then go the me22n and message and click on output type and select it and press repeat output . it will generate the output. if it is not triggring then let me know it

    Regards

    Rashi K

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Nov 22, 2016 at 10:46 AM

    It will work for them you can go for me9f enter the PO number and maintain processing status 0 if it has not been maintained or 1 if it has been processed succesfully 3 if it has been processed incorrectly.

    Hope it will work

    Regards

    Rashi K

    Add comment
    10|10000 characters needed characters exceeded

  • Nov 22, 2016 at 11:03 AM

    If you just enter an output type in the next line in the messages screen manually then it is certainly not going to copy the information from the exiting old message and not accessing the message determination either.

    Add comment
    10|10000 characters needed characters exceeded