on 06-16-2009 11:32 AM
Hi All,
We have a DOE 7.1 SP7 installation.
While we were uploading NWMCLIENT.sca throught transaction SDOE_UPLOAD_ARCHIVE, it failed.
It gave the error: "Unable to find generated objects in repository".
Can you please provide us any hint or solution to solve the same?
Best regards,
Roberto.
Edited by: Roberto Gutierrez on Jun 16, 2009 12:33 PM
Hi,
Can you check if you see the data objects are generated and showing status active and green in transaction SDOE_WB for your SWCV?
You should also check for the SWCV : SAP BASIS* and all the objects should be generated and showing green status.
Please follow the steps in the config guide:
[http://help.sap.com/saphelp_nwmobile71/helpdata/en/45/17a790d8000064e10000000a1553f7/frameset.htm]
Regards,
Liji
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Roberto,
First step is to check if all the SAP Basis Data Objects are generated and error free.
It could also be that if the SCA that you are uploading is a huge SCA, then the transaction may timeout. In such rare cases, you may get this error(unable to find generated objects). You can check tcode ST22 and see if there is a timeout error. If thats the case, you can increase the transaction timeout for your system and re-uplaod it again. It should solve your problem.
Best regards,
Vinodh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
Can you check if all the data objects under swcv - SAP BASIS 7.10 are generated properly?
If not those needs to be generated. Also check whether activities part of initial set up are performed. The corresponding transaction is sdoe_sr. Check the documenation for initial set up in DOE.
regards
rohit
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
87 | |
10 | |
10 | |
10 | |
7 | |
6 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.