Skip to Content
avatar image
Former Member

/SAPSLL/CD_STATUS_GET standloane test gives the right resullt but Not through the ECC Exit calll

HI Dave ,


Could you please help on this ?

1. I create a order in SAP ECC . 2. It goes to GTS for SPL Check .3. Since it does not have the right partner in ECC it doesnot . 4. I change the partner in ECC which is SPL hit . 5 . Now it goes to GTS and get blocked in ECC . 6. Now GTS needs to send a retun code 'SPL6' for the Block and SPL5 for release . However in ECC when I execute the FM

/SAPSLL/CD_STATUS_GET indiviadally I get the required result . But when I call this through the exit in ECC I am not getting the right retun code SPL6 . This is the error only when it is Blocked in GTS . However I am getting right code back in case of SPL5 and others . When I debut I see

gv_first_callis intitial . If it is X it goes inside and refresh the same anf get the fresh value

IF NOT gv_first_call IS INITIAL.
REFRESH gt_result.
CLEAR: gt_result,
gv_first_call.
ENDIF.

So what might be the reason ? Appreciate your input .

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Dec 05, 2017 at 05:03 PM

    Hi Ranjan,

    If the symptom is repeatable, you should create an OSS Incident so that SAP can verify and fix.

    Best regards,

    Dave

    Add comment
    10|10000 characters needed characters exceeded