Skip to Content

Error Connection reset using ODATA Adapter in PO

Hello Experts,

I need to send information from ECC to Hybris C4C using the ODATA services in a synchronous interface, we installed the adapter and configured objects in ESR and Integration Builder, but is giving me this error when sending the message:

The channel appears as “Functioning”, when I ping shows the same error:

This is the Odata communication channel:

I tested the service using SOAP UI and works fine

I am missing something? Is there something wrong with the communication channel? Im working with PO 7.5 SP03.

Thanks in advance.

0.jpg (156.6 kB)
4.jpg (127.9 kB)
1.jpg (87.5 kB)
2.jpg (93.8 kB)
3.jpg (91.2 kB)
Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Jan 16 at 09:18 AM

    Dear Eduardo

    As per the error screenshot, It is possible it is perhaps being caused by a proxy on your network.

    It says connection reset.

    Please check if the proxy/firewall settings are maintained in SAP PI configuration

    Thanks and Regards

    Sikander

    Add comment
    10|10000 characters needed characters exceeded