Skip to Content
avatar image
Former Member

Issue with endSeparator in File Adapter

Hi,

I have to load an (EDI) File that looks like this when I open it with a text editor:

BEG00NEC3315858400061226…CURCYUSD…PERBD etc.

I was told that the Segment End Separators (...) represent HEX 85. My understanding is that the endSeparator in the File Sender Adapter Content Conversion has to look like: '0x85'. But this does not work. I also tried out the following without success:

'0x0085'

'...'

...

Can somebody tell me what I have to use for the endSeparator?

Thanks in advance.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • Best Answer
    avatar image
    Former Member
    Apr 17, 2007 at 10:33 AM

    Hello,

    Please follow the link below it should solve your issue.

    /people/shabarish.vijayakumar/blog/2005/08/17/nab-the-tab-file-adapter

    Regards,

    Add comment
    10|10000 characters needed characters exceeded

  • Apr 17, 2007 at 12:18 PM

    hi,

    Try <b>'0x2E'</b> insted of '0x85' and check it once again.

    as for <b>'.'</b> the equivalent hex notation is 2E

    check this link

    http://www.asciitable.com/

    Regards

    Sachin

    Message was edited by:

    Sachin Dhingra

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      hi,

      If adapter monitoring shows up and runnning then go to tcode : SXMB_MONI

      check the message status...it will explain what are the steps gone through the..

      If message is not coming then the problem in File content conversion...if any problem in FCC it won't shows any error message in Adapter monitoring.

      You need to check throughly your FCC parameters are passed correctly...if FCC parameters are correct file will pick and it will converit into SOAP-XMl format...otherwise no message will appear.

      Regards,

      Venu.