IP30/IP30 H difference

[preethialevarthi]

Hi Team,

Why I am not seeing the details in the IP30H in S4? Normally when I run IP30 in R3, I would see the details of orders and notifications created or the details of the errors. When I run IP30H, I do not see the same level of detail. Is that expected in IP30H or should I be able to see the same level of details.

I have a maintenance plan which ran in IP30 in R3Q and IP30H in S4G. They both ran successfully and created work orders/notifications but in the R3Q it has details while the S4G only shows it was scheduled even though orders were created.

[paul_meehan]

Details of order and notifications generated are not shown in the log from IP30H. See the Note on this page that references that

[yogananda]

preethialevarthi

IP30H is a mass scheduling transaction that schedules all maintenance plans that are due within a specific timeframe ¹. It automatically schedules maintenance calls and call objects for all maintenance plans that are due within the specified timeframe.

It is possible that the level of detail you see in IP30H in S4 is different from what you see in IP30 in R3. This could be due to differences in the configuration of the two systems or differences in the versions of the software being used.

If you are not seeing the same level of detail in IP30H in S4 as you are seeing in IP30 in R3, it may be worth checking the configuration of the two systems to see if there are any differences that could be causing this issue. You may also want to check the version of the software being used to see if there are any differences between the two versions.

I hope this helps!