Skip to Content
0
Jun 24, 2019 at 08:45 AM

Measuring point an reverse counter process in SAP PM

753 Views Last edit Jun 24, 2019 at 09:22 AM 2 rev

Dear All,

I am NEW in SAP PM module and facing some issues while implementing measuring point of equipment with reverse counter.

1) Maximum limit of Measuring point is 18.5 mm

2) Minimum limit of Measuring point is 5.5 mm.

3) Set counter over reading is 18.5 mm.

Now while doing the measurement document facing some error.

System is not allowing to maintain the counter reading 15.5 mm. Document is attached for ready reference.

Unable to understand the system behavior.

Request you kindly share any idea so that I can overcome this problem.

Thanks in advance.

Best Reagrds,

Koushik


Attachments

ik03.jpg (59.6 kB)
ik03-1.jpg (45.2 kB)
ik11.jpg (71.4 kB)