on 05-11-2016 5:32 PM
Hello All
I am using TDMS 4.0, time slice scenario to copy prod data to dev system. In the data transfer phase a table IBINVALUES is divided into 7106 portion where 4 portion are into error. These error are because of time_out dump in reciever system. I have taken care of this problem but my doubt is if I will restart the data transfer of this table again then would it copy all the portion or the 4 portion that comes into error?
I have search over the SDN and SAP note but i think this is not mentioned anywhere so I though if I can help from experience member.
Appreciate any comment on this.
regards
rishab
Hi Rishab,
When you re-execute the step, it will automatically re-execute the remaining portions only, provided there is no inconsistency in state management.
Mostly, since you have had an issue with time-out (hope you have extended the rdisp/wp_max_runtime parameter), there should not be any state inconsistency in your package.
Please try re-executing the step and if you get duplicate key error, try the option suggested by Manas above.
Thanks,
Shouvik
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello Vinit ,
If you restart the data transfer it will transfer the remaining portions only , although sometimes it does fails with duplicate entry error , so you can just change the write behavior for that particular table to modify and re-execute .
Hope it helps you.
Regards,
Umesh Patel
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
84 | |
10 | |
10 | |
10 | |
7 | |
6 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.