Skip to Content
avatar image
Former Member

How operands for two rate registers get populated with their respective registers consumption value

Hi Friends,

I am trying to create Rate steps for two rate registers meter(on peak and off peak) using single RATE, please see the below table for RATE steps for both the registers,

R1_onpeak and R2_offpeak operand's category is quant and operand usage  is register, can anyone let me know how operand R1_onpeak and R2_offpeak get populated with their respective registers consumption value because I haven't seen anything which relate these operands to their respective registers, In case of single rate meter it obvious since only one register is there.

Variant            input operand            input operand               output operand

Quanti01         R1_onpeak                 R1_price                    R1_amount

Quanti01         R2-offpeak                  R2_price                    R2_amount

Many thanks

Veer

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Sep 27, 2015 at 06:23 AM

    Hi Veer,

    First of all my recommendation will be to create two different "register rates" if consumption is coming from two different register.

    So create Rate 1 - PEAK_RATE

    &

                   Rate 2 - OFFPEAK_RATE

    Do the rate determination using "register permissible rate type"

    Determine "PEAK_RATE" with  "PEAK_RT" rate type

    &

    Determine "OFFPEAK_RATE" with  "OFFPEAK_RT" rate type       


    Now below is your answer


    When you will install the device (with two register)


    Put rate type - PEAK_RT for register which is capturing peak consumption

    &

    Put rate type - OFFPEAK_RT for register which is capturing off-peak consumption


    So this way "PEAK_RATE" will get peak hour consumption & "OFFPEAK_RATE" rate will get off-peak hour consumption.

    Add comment
    10|10000 characters needed characters exceeded