Skip to Content
avatar image
Former Member

Percentage does not defualt for Benefit enrollment (IT 0169 - Savings Plan)

Hi,

When I try to enroll a person for Savings Plan.  The enrollment screen contains blank value in the field for percentage.  When I try to enter a wrong percentage the system throws an error message.  If I try to enter the actual value and save,  the record gets saved (stores in IT169).

Further, if I try to save the record without entering any percentage, the record gets saved  in IT0169 - Savings Plan with a old percentage which is mentioned in table  V_74FH_C, and not the current percentage.

Kindly tell me as to what should be done to default the right percentage in benefit enrollment screen during enrollment.  We also debugged and found that the plan fetches the right percentage but its not populating on the enrollment screen.

Thanks and regards,

Victor

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Jun 15, 2015 at 07:56 AM

    Hi Victor,

    As mentioned by Remi, we have to enter percentage on IT0169 and configuration can only check whats minimum and maximum values for percentage entries.

    Although give it a try using dynamic action using table V_T588Z for IT0169 to default when a plan is being delimited or set-up.

    Thanks,

    Ameet

    Add comment
    10|10000 characters needed characters exceeded

  • Jun 12, 2015 at 04:30 PM

    The Savings Plans were built for plans where each employee can choose the contribution rate, not for plans where the rate is fixed.

    You can set Minimum and Maximum "Pre-Tax" and "Post-Tax" Contribution Rates in the configuration tables, but the Contribution Rates must be defined in each IT0169.

    Each time our Pension Plans inform us that the next year's rates change, we must first configure the new rates in the system, and then create a new IT0169 for each employee who is registered to the Pension Plan whose rates changed.

    If SAP has developed something to solve this hassle, I would appreciate to hear about it.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Jun 12, 2015 at 04:58 PM

    Hi Remi,

    Thanks for your kind response.

    In Table V_74FH_C we have defined the Pre tax and post tax percentage for the Benefit Area, Benefit Plan, EE Contribution Variant & EE Contribution Group.  The system at time of enrollment for new hires.  The field for percentage in the enrollment screen shows blank.  It does not default the applicable Pretax/ post tax percentage (8.5 and 10) as shown in the table.

    Thanks and regards,

    Victor

                                  

    SL. EE Contr Group Start End Pretax Post tax 1 0002 6/18/2011 6/13/2014 7.8 9.3 2 0002 6/14/2014 12/31/9999 8.5 10
    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Rémi Corriveau

      Hi Remi,

      Thanks for your kind reply.

      As you said.  I will check with SAP and  put an OSS query and see if SAP has come up with something new. Further, I will keep you posted on any new developments, if any.

      Thanks and regards,

      Victor