Skip to Content
avatar image
Former Member

No number range found for object ADRPSTCODE

I used SR10 to create a new city St. johns. I entered region NL(this region was just added to the config.). Next I click Postal codes to create a new postal code. I entered the postal cod(A1A 5G9) and clicked the create postal code but got the error message: "No number range found for object ADRPSTCODE".

The new region NL was just added to the config. by spro-> 'insert region'. What else I need to config. to combine the new region, country and postal code?

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • Best Answer
    Sep 25, 2013 at 08:01 PM

    Use transaction SNRO for object ADRPSTCODE to see what number ranges are defined for the object. You might then need to create a new one. If you are giving the ID for the code the same as the actual value, then you need an external number range which can have values A to ZZZZZZZ.

    Add comment
    10|10000 characters needed characters exceeded

  • Sep 25, 2013 at 08:01 PM

    Sounds like you need to check the SNUM transaction for that object, and define a number range.

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Hi,

      If ur requirement is to maintaine the Regional Postal St. then u can enter the Postal Code in the CITY , maintain via T-code SR30.

      Regards,

      AnUrAg