Measuring Point History

[Former Member]

Hi! Experts

We are working with MAM25 SR5 and we have the following quastion regarding measure point history:

Currently we can see only one history document on the PDA. It is the last one that was registered on the system. But my users want to see at least the last 3 ones if they already exist on the backend system. Is it possible ?? how can we show it ??

Backend:

The perform general setting

Measuring Points:

Variant: XXXXXXX

Vianta: YYYYYY

We did active the ckeck box Last Meas. Document in order to get it on the history parton the PDA.

My questions are:

1. Should I take that check box out in order to get more than one historic information ???

2. Where should I control how many historic documents I want to see on the PDA ??

Thank you very much

Xiomara Aramendiz

[Former Member · Accepted solution]

Hi Xiomara,

have a look into SPRO - there you should see the question if you want the history or not. And related to that you can enter how many you like to see.

If that is not the case in your system, then simply enhance the GETDETAIL handler for this object to return more then the last history.

Hope this helps.

Regards,

Oliver

[Former Member]

Hi! Oliver

We have no option into SPRO about how to say how many history document we want to see.

How can I enhance the GETDETAIL handler for this object in order to return as many as history we want to ??

Thank you for your cooperation