on 12-10-2013 6:46 AM
Hi,
I am cretting measuring points through LSMW and while uploading the data i found that system is not updating the value of lower range limit in Additional data Tab.i have gone through suggestion given by experts to flag the Negative Vals Allowed in Characteristic basic data but our business persons are not ready for flagging field Negative Vals Allowed as they do not want to allow any negative Value.
Is there any solution to create the measuring points with upper and lower limit without flagging Negative Vals Allowed in characterisitc.Please note that business person has to create measuring points in huge numbers so we cannot suggest them to create manually with Transction Code IK01.
Thanks
As mentioned in other post, you can't upload lower limit unless that characteristics has marking as Negative Values acceptable.
Its not about LSMW or BDC, I think. Its about SAP.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
What field name have you given to this field in the LSMW
Also make sure the output file has the value - i.e the conversion worked OK.
PeteA
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
If you are creating the Measurement Point in LSMW via BDC, then run the BDC in foreground mode. This may help determine the issue.
Are there any warning/error messages issued?
PeteA
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
96 | |
10 | |
10 | |
5 | |
3 | |
3 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.