BOM and alternative unit of measurements

[former_member117]

I have the following BOM:

Item level 1 ''X'' > BuoM at Mat. master = EA

Sub Item level 2 ''Y'' (part of X) > BuoM at Mat. master = FT2 (square feet)

Both materials have only their BUoM (Meinh) defined in MARM.

Will it cause any problem with quantity calculation / rounding in ECC?

Should the Sub Item ''Y'' have an alternative UoM in Mat. Master or anywhere else?

Thanks

Br,

Geri

[Ritz · Accepted solution]

gergelykocse,

I dont think you will face any issue as long as Y is child of X and there is not direct conversion between X and Y.

Thanks

RD

[former_member117]

Thanks it turned out a custom code issue during BOM explosion, non-standard. The question is therefore a bit irrelevant.

Geri

[former_member760464]

The manufacturing batch unit of measure is set up as an alternative unit of measure on the Item Units of Measure page on the item to be produced. The batch unit of measure will not replace the base unit of measure on the item. Create a production BOM for the item set up with the manufacturing batch unit of measure.

liteblue.usps.gov