01-31-2011 11:20 AM
Hello ,
I created report with selection screen . When I run the transaction and hit execute F8 the program is NOT executed at all and transaction ends up on "SAP easy access" screen.
I checked in debugger and I realized that program is executed until the event "start-of-selection" on that line execution stops.
In that moment sy-ucomm = 'CRET'
Although when the program is executed from SE80 ( direct execution ) everything works well in this case sy- ucomm is initial ( no value)
Please advice .
Krsto
at selection-screen.
perform layout_validation .
start-of-selection. - execution stop s on this line
select * from zlabveri
02-01-2011 1:08 PM
so what did the dump (read it in trans ST22) tell you the problem is? Read the dump and fix the error. Forum participants have no psychic antennae nor can they remote view your dumps
02-01-2011 1:33 PM
By reading whole thread you should understand that ST22 doesn't have nothing with it.