Skip to Content
Former Member
May 10, 2013 at 07:24 AM

Screen (configured by dynamic actions) repeats itself during PA40


Dear Experts,

I was trying to configure a dynamic action, as shown below:

Objective: To create a task in IT0019, defaulted as "Contract Expiry", whenever I perform a hiring action for an employee whose employee group is not "Permanent".

In my context, "Contract Expiry" task is labelled as Z2, and the hiring actions are labelled as Y0, Z1, Z2 and Z3. PERSG = 1 refers to employee group "Permanent".

The above commands actually work fine when I execute the hiring action via PA40, except that when I reach Infotype 0019 screen, the screen gets called up correctly but at the same time, the screen would repeat itself forever unless I skip to the next screen. Is there anything wrong with the commands above that cause this to happen? Can I re-write the above commands so that the screen appears just once?

I do not have IT0019 in my info group, thus I believe that the repeated screens have got to do with my dynamic action commands above.

Appreciate all help and advice. Thanks!