I don't see messages from adapter engine in SXI_MONI

[danielgonzalez]

Hello all,

In a fresh PI 7.1 installation I've developed a SOAP-> RFC scenario and it turned out messages from the soap side (outbound request and response) aren't being displayed in the TS SXI_MONI. I do see them in Runtime Workbench under Adapter Engine.

I'm not using Integrated Configuration.

Please, any suggestion to make them appear in SXI_MONI.

[former_member184789 · Accepted solution]

Hi,

It seems that the  parameters eg logging_sync is not setup in SXMB_ADM. You can refer to Michal's blog:

http://scn.sap.com/community/pi-and-soa-middleware/blog/2005/05/10/xi-i-cannot-see-some-of-my-messag...

[Bhavani_Baisani]

Test scenerio in test configuration in ID. check as discussed samiullah. can you refer the below blog

http://scn.sap.com/thread/1933586

[samiullah_qureshi]

Your scenario seems to be Synchronous communication. Logging of successful synchronous messages will be disabled in newly installed server. Your can switch on logging of sync messages using the parameter LOGGING_SYNC parameter by setting its value to 1 through SXMB_ADM transaction.

Also, refer Michal's blog for more details:

http://scn.sap.com/community/pi-and-soa-middleware/blog/2005/05/10/xi-i-cannot-see-some-of-my-messag...

Regards,
Sami.

Message was edited by: Samiullah Qureshi

[former_member303666]

Hi,

For visuability of messages in Integration engine level. need to add some parameters in SXMB_ADM(Administration)

TRACE_LEVEL  set current value as a 3 and check it.

Regards,

Kesava.

[Former Member]

Hi ,

It seems like JCO connection issue.

What is the status of the message in Adapter engine?

[naveen_chichili]

Hi,

check if you have successfully finished post installation steps.

Also Seems there is an issue with Integration engine configuration.

You need to configure Integration engine in SXMB_ADM and try again.

Regards,

Naveen.