on 04-16-2013 4:29 PM
Dear experts,
I had the assumption and understanding that the InfoCube Persistence behaviour as 'BWA only' can be set only during the creation of the InfoCube. But I cannot find any document, forum post or note clearly indidcating this.
Please let me know if the InfoCube persistence behaviour as 'BWA only' can be made later after development of a cube or for an existing cube? Consequently, can an existing Standard Infocube with no BWA index be changed to have persistency on BWA only?
It would be great if some document or link can be provided to support this too.
Regards,
Abhishek.
Dear all,
Still awaiting responses. Any document/ link providing further information on InfoCube Persistence will also be helpful.
Regards,
Abhishek.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Abhishek,
I have tried to change the Persistence Behaviour for existing cube, there is no way to change it. I believe it has to set while creation. Check below links for basic understanding/functionality of 'Persistence Behaviour' of InfoCube.
Hope it helps,
Umashankar
Thanks a lot Umashankar, for the response. It is the same understanding that I have.
However, I could not find any standard content verifying the same. It would be great if you can share any document on it because the link you shared mainly deal with creation of InfoCube with Persistence.
Anyways, it was good to know that it was not just me who could not find an option to change the persistence behaviour.
Regards,
Abhishek.
User | Count |
---|---|
87 | |
10 | |
10 | |
9 | |
6 | |
6 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.