CTM Deletion

[Former Member]

Hello Everybody

WHy is CTM not deleting the SNP generated or Manually created Preqs while replanning for all orders with the deletion mode selected as "Delete orders that are not firmed".

Thanks

Rachel

[sourabh_jain66]

Hi Rachel,

Check if due to some reason these orders are not "Output fix" or falls any of the definition of fixed orders.

1. CTM considers orders which are not inside the planning horizon as fixed. An order is considered fixed if the start date is before the planning start date or if the end date is after the planning end date. Orders that are lying inside the planning horizon and have been pegged to orders or demands outside the planning horizon are considered fixed.

This effect is amplified when you use dynamic pegging.

2. CTM does not delete any planned orders within the production horizon. These orders are considered fixed. The horizon starts on the system date (or the date you specified as the planning start in the CTM profile).

3. Orders which have at least one component that does not belong to the master data selection of the CTM profile are considered fixed.

Rgds

Sourabh

[kenneth_snyder]

Probably because manually created orders are normally "fixed".  Did you create these orders in SNP PB or product view?

[Former Member]

Hi Sourabh

I am not using PPDS...its only SNP...r u points still valid?

[Former Member]

SNP PLanning Book

[kenneth_snyder]

There is a setting in Material Master that determines whether the SNP Planned orders created in PB are fixed or not... Did you check this setting.  If you look at order in PRoduct View, is the order firmed?

[sourabh_jain66]

Hi Rachel,

Yes these points holds valid for SNP as well.

Rgds

Sourabh