Skip to Content

Number of defect Observed (ANZFEHLER ) is not getting calculated using formula " C3" .

Hello ,

Number of defect Observed is not getting calculated in the target characteristics using characteristics formula " C3" .

I have recorded the result and also maintained the defect code and the number of defect for the source characteristics but the value is still not getting calculated in the target characteristics .

On further investigation, It was also observed that the value is not getting updated in table QAMR for the field " Number of defect (ANZFEHLER)"

Kindly help.

Regards,

Sujit Prasad

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

0 Answers