on 03-18-2013 3:24 PM
Hi All,
When i run a particular DTP it throws an error with the follwing description "
I tried to debug by putting a breakpoint in the transformation but it still throws the same error instead of going to the debugger screen.
This means that it doesnt even reach the code of transformation but somehow throws an error before that.
Can some one help?
Hi,
After puting breakpoint also you will need to execute DTP with 2nd option in execition tab which is for debugging then only it will go to debug screen.
Regards,
Dipti
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Yasir,
Do you have a routine in the filter? Or where exactly do you have a routine?
Best Regards,
Marcel
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
There is no start and end routine written in the transformation b/w the two infoproviders. Only one to one mapping.
Some more information which might help.
1. The DTP loads data from one inforcube to another infocube. The target infocube is used for archiving purposes.
2. Just recently i ran a report RSSM_REDUCE_REQUESTLIST on the source infocube (which deletes the transparent requests from the tables like RSICCONT etc).
Hi Yasir,
Cross check your routine code if any and check it syntatically correct or not. take abap expert help.
Thanks
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
101 | |
13 | |
13 | |
11 | |
11 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.