Our R/3 quality system was recently refreshed. I am not able to run a CO-PA Delta. The error states DataSource does not have the status of the source system in the Business Information Warehouse. It suggests re-transporting the DataSource and activating the Transfer Rules. When I create the transport for the R/3 DataSource, I'm getting the DataSource and 7 table contents but not the Z* table. Is this correct? Did I create the transport correctly? What is the procedure for getting CO-PA deltas to run again after an R/3 refresh?
Yes I am transporting from development system to quality system. The table is not assigned to the $TMP transport package. It has the same ZBW package as the tranport.
in se11 display your table and go to -> environment -> transport organizer -> and check in which request is your z* table then release&transport this request
I performed the steps outlined in your post. The transport listed only shows the DataSource and the Table Contents. I do not see a listing for my Z* table. Do I need to transport the Z* table if I didn't make any changes? The only reason I'm transporting is to solve the issue caused when our R/3 quality system was refreshed.
I think that if your Q system has your Z table active, then retransporting DS activation request from Dev, replicating DS in Q and activating transfer rules should do the job.
Just to let you know, we get the same message every once in a while and usually if you re-activate the transfer rules all is well - even though it says to replicate, we have found that re-activating the transfer rules is what is needed.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.