on 03-08-2013 10:27 AM
Hi Experts,
Issue: When i open a report in Bex analyzer, run it once for the selections in which there is a hyphen(-) contained in name. It executes fine.
Now, if i open the variable selection screen and see those selections that I have made earlier, I will see a pair of "\"(back slash) with hyphen. i.e. "..\-\.." in variable selection screen.
It increments each time i open the variable selection screen and runs the report i.e. number of "\" increments by one ("..\\-\\..") after each refresh of report.
I am using SAP GUI 7.2 SP 4.
Any pointers will be highly appreciated.
Thanks
Nishant
Hi Nishant,
Please apply following notes which should solve your issue.
1540273 - Different Issues with selector on F4
1806725 - Selector: Contains patters operator gets converted to equal.
These notes contains ABAP corrections and you can apply via SNOTE.
Regards,
Amit
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Please make sure you have latest frontend patches as per below wiki:
http://wiki.sdn.sap.com/wiki/display/BI/Current+BI+ADDON
Regards,
Arvind
Dear Nishant,
I would suggest you to please implement below Note through SNOTE.
Note 1540273 - Different Issues with selector on F4.
Also makse sure that you have installed the latest frontend patch as per below wiki;
http://wiki.sdn.sap.com/wiki/display/BI/Current+BI+ADDON
Regards,
Arvind
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Nishant,
Can you please refer the following note and check whether it helps you:
1540273 - Different Issues with selector on F4
Thanks & Regards,
Sapna
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
84 | |
10 | |
10 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.