Skip to Content
avatar image
Former Member

getting error while executing CMP2 workforce planing?

Hi PS Guru,

I have created workforce planning profile and project with network and activities add work center and activity, then execute CMP2 but getting error.

No requirements were found for the selection criteria

Message no. C#043

Regards,

Aryan

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • avatar image
    Former Member
    Mar 08, 2013 at 09:13 AM

    Hi Aryan,

    Is work center added in the activity have Capacities defined.

    Also check if Calculation key is maintained in the activity as ' Calculate Work'

    Check few points mentioned in below thread as well

    https://scn.sap.com/thread/1628637

    Regards

    Tushar

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Hi Aryan,

      Check whether resources are assigned to Work center.

      Also check settings of Capacity requirement in configuration of Control key in OPSU.

      Compare your workforce planning profile settings with standard profile 1302.

      Regards

      Tushar

  • avatar image
    Former Member
    Mar 11, 2013 at 05:17 AM

    Hi,

    As Tushar has mentioned above, check if the work center that you are using has Capacities defined. Also, have you defined any work in hours for the activity?

    You can also check your workforce planning profile and if required do necessary changes to resolve this.

    Revert with your findings.

    Regards,

    Gokul

    Add comment
    10|10000 characters needed characters exceeded