on 03-07-2013 10:36 AM
Hi,
I have created a fpm application based on OVP.I have created the application configuration when i run the application configuration then it show a blank page .
I have one main page then i have inserted the form UIBB in this main page .I also created the feeder class and use these feeder class to configured the form configuration.I have attached the screen shot of the application configuration please tell me what is wrong in configuration.
Thanks
Regards
Deepa
Hi,
Test whether you are able to see the preview in the configuration editor by clicking on Preview UIBB.
Or after executing the application, right click and check if the UIBB block has been hidden .
Best regards,
Arun Krishnamoorthy
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Your configuration looks fine to me. I have set the same configuration and it works fine for me. I guess you are trying to run the webdynpro application directly form the FPM component FPM_OVP_COMPONENT. If that is the case add the application paramter wdconfiguration id to the webdynpro application and provide your configuration name there and test it.
Best Regards,
Arun Krishnamoorthy
Hi,
I am not sure what mistake you would have done. Why dont you cross reference the steps with the document in the below given link.
http://teamabap.com/?attachment_id=3424
Best regards,
Arun Krishnamoorthy
User | Count |
---|---|
89 | |
10 | |
10 | |
9 | |
6 | |
6 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.