Create RFC connection to use with Bex web application on BO 4 SP05

[Former Member]

Hi everybody,

I m trying to configure Bex web application on BO 4 SP05 by following the configuration guide in:http://wiki.sdn.sap.com/wiki/display/BOBJ/Configuration+steps+to+integrate+BEx+Web+applications+into...

I have applied all steps end to end, finally I get an error when I try to open a session on the Bex application web from the launch pad.

I guess the problem is on the RFC destination because when I tested the RFC destination I get these errors:

Any suggestion would be helpful

Thank's

Abdess

[Former Member]

Any suggestion may be helpful

Abdess

Thanks

[robertot4s]

Hi,

Review the "step 3 : configure the Adaptive Processing Server". In this step you configure the program ID and the gateway data. If these parameters aren't properly configured, the RFC destination won't work.

Regards,

Roberto

[Former Member]

Thank's Roberto,

I have applied all steps correctly! but I still cant connect from Bex apps on BO 4 SP05. Like you can see from the image error above, it's about certain program that isn't registred!!

Any help plz.

Abdess

Thank's

[robertot4s]

Hi,

Can you add to the post the configutarion that you have done in "step 3 : configure the Adaptive Processing Server" and in the RFC destination?

Regards,

Roberto

[Former Member]

Hi Roberto,

Below snapshors for RFC and APS configuration:

Thank you for you help

Abdess

[robertot4s]

Hi,

Try writing the JCo Server Gateway Service in lower case: "sapgw00".

Regards,

Roberto

[Former Member]

HI Roberto,

I tried it, but it still gives the same error message!

Regards,

Abdess