Skip to Content
avatar image
Former Member

Manual transport Connection for SNP and DP

Hi everybody,

we want to transport our planning books, areas and structures to our productive system by using transaction /SAPAPO/TSOBJ.

However we are not entirely sure which settings/radio buttons we have to check in the area Transporting planning areas () in order to complete the transfer successfully.

Does anyone have further information and explanations regarding the various options?

Thank you in advance for your replies.

Best regards

Mitch

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • avatar image
    Former Member
    Feb 27, 2013 at 11:45 AM

    Hi Mitch,

    Generally options of "With data source transport" and "With InfoObject transport ( key figure & Characteristic)" are selected.

    Other then this if it is required to transport selection profiles, which doesn't make much of the sense and other options for your scenario you can select the relevent options.

    Rgds

    Sourabh

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hi Mitch,

      Did above reply helped in any sense, or still searching for some more answers here.

      Rgds

      Sourabh

  • avatar image
    Former Member
    Feb 27, 2013 at 07:59 AM

    Hello Mitch,

    A related issue has been discussed in the below thread

    http://scn.sap.com/thread/3310030

    Hope this helps you.

    Regards,

    Anurag

    Add comment
    10|10000 characters needed characters exceeded