on 01-23-2013 4:57 AM
Hi,
I have added field BADAT-PR creation date in the extractor structure of 2lis_02_itm. I have checked unhide in rsa6, but still its not displaying any values. Is there anyway I can get this field populated without writing code for it?
Rgds,
Priya.
hi priya,
if the BADAT field is not part data source need to go user exit.
see below links
http://scn.sap.com/message/10692026
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Priya,
For enhanced fields need to fill with historical data.so at ECC side delete setup tables for application 02, using t code LBWG,
after the deletion fill the setup tables by using t code OLI3BW.
Check at RSA3 ecc side.
Regards
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
ok, go to ecc side LBWE, click on data source link, select BADAT from Communication str to your data source,mean, there will be pool sources right side, if badat is there move that right side, then save, active data source, un hide this option.
a s you said you added field to Extrcatr structure, how you added, with ZZ or directly?
when this field is available in comm str, better to use trhu there only.
regards
Hi,
I think you need to go for customer exit enhancement.Even though its available in communication structure but it points to MCEKPO-BADAT whereas this field available in EBAN table not in EKPO.
You can also check the same.It would be better if you append Z structure and add new field.
Write the code in cmod selecting the value for it based on proper combination of where conditions.
Also would request to log the ticket with SAP to check why the value is not getting populated.
Regards,
AL
Hi,
Is your datasource in active mode.I understand you have enhaced the datasource with this field from communicantion strucutre.
Did you refill the setup table?
Also check if you have done the above steps---Is data there in base tables or not. EKPO.
Hope that helps.
Regards,
AL
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Delete setup table once for 02 application and rerun statistical Setup run.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
93 | |
10 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.