on 08-05-2005 12:38 PM
Hi Forum,
I try to figure out how to use the receiver determination. I have two receiving SAP's. The Idoc that I have created should go to the right system dependent on a value of my payload message. In the messages I have the following (Record 1..many):
If I replace one of the conditions to:
(/p1:MouldCreateDataTarget/Records/Record[1]/TARGETSYSTEM ≠ EU) (not equal)
then it went to that system. That means the channelconfiguration of the systems are OK.
I have also tried to set the XPATH to things like
/p1:MouldCreateDataTarget/Records/Record/TARGETSYSTEM = AS
or
/p1:MouldCreateDataTarget/Records/Record[TARGETSYSTEM = 'AS'] EX
or
/p1:MouldCreateDataTarget/Records/Record/TARGETSYSTEM[text() = 'AS'] EX
or have put the right operand in single quotes or double quotes,
but nothing helped...
Any new ideas out there????
Kind regards
Manfred Schmidt-Voigt
Hi Manfred,
did u use grafical tool for X-Path? If not, may u made a small mistake. Probably the namespace or praefix. Plz try //TARGETSYSTEM='EU' . The parser will take first field TARGETSYSTEM it finds. Control in monitoring if incoming message including that field with value 'EU'.
Regards,
Udo
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Manfred,
The problem is with your receiver determination.
Even if you have a single send step, you need to have two receiver determination for that sender as you need to send the data to two SAP systems.
Moreover check with the sample BPM under the component SAP BASIS, multicast sequential/parallel that whether you have correctly created containers (multiline) of type 'Receiver' or not.
I hope it helps,
Thanks & Regards,
Varun Joshi
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
93 | |
10 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.