transport remote cube-- no source system available

[Former Member]

Hello everybody,

i had defined a remote cube in bw. Its source system is assigned to self bw.

Now i transport this remote cube to test-system. And there is no source system more available.

Where can i assign in transport queue this connection?

Thank you.

Regards Jürgen

[Former Member · Accepted solution]

Hi Aneesh,

indead in this table is no entry of my source system in the test system. What must i do to transport?

Thank.

Regards Jürgen

[Former Member · Accepted solution]

Try executing teh fucntion module RSOA_VCUBE_CONNECT_SOURSYS.

[Former Member]

Hi Aneesh,

that is the solution.

Thank you.

Regards

Jürgen

[Former Member]

Hi Jürgen Löwenstein ,

Do not forget assigning points to Mr.Aneesh. If

benficiary rewards the points to the helper(who really helped), then it really makes them to give answer to further Postings.

With rgds,

Anil Kumar Sharma .P

[Former Member]

Hi Anesh, Anil,

in rsa1 the source system is mapped right and conversion after transport is also active.

In the development system the remote cube is ok with its source system.

Only in the test system there is connection to source system not defined.

In test system with its context menu on remote cube,

it is possible to assign source system manually, but it is not allowed.

Regards Jürgen

[Former Member]

Jurgen,

Is the InfoSource transported without any problems?

Check if there is an entry in table RSOACUBE_LOGSYS.

Cheers

Aneesh

[Former Member]

Hi,

Have you maintained the "Target source system"(PRD BW) name for 'Orginal source system'(DEV BW) in the table 'Conversion of source system names after transport'.

With rgds,

Anil Kumar Sharma .P

[Former Member]

Do you have the source to target system mapping deinfed in the test-system?

RSA1 --> Tools --> Mapping of source system names