on 12-13-2012 6:15 PM
We are implementing the MRS solution with MRSS 200
Level 006
Support Package : SAPK-20006INMRSS
R/3 4.6.
I completed the base iine configuration fo the MRS with the
following configuration settings as detailed in the MRS 200 config document.
- Work Center Profile
- Check Profile
- Alert Profile
- UI profile ( Since we are not using the UI portal for MRS,
hope this is is not needed for the planning board profile)
I also created the resource planning board profile and updated
the same with the work center profile / Check profile and Alert profile.
In addition to the above I mapped the plant maitenance order
types with the export function module and the operation control key PM01.
Since we are integrating HR module with the MRS I activated the
HR active check box.
In the WFM core I defined the Logical system and RFC
destination.
For the WFM core business setting , I defined the time
specification types and assigned them to the resource types.Defined the
dispatcher and trategies for WFM.
Based on the recommended config settings documents for MRS
release 200, I completed the configuration of the above settigns.
Then I executed the program for transfering the MRS status to
WFM core.
I executed the transaction /MRSS/WFM_HR for completing interface
transfer between HR > WFM core.
I completed the base iine configuration and when I am trying to
launch the planning board with the following transactions
/MRSS/PLBOORGM - Planning board for org.units and
/MRSS/PLBOSRV - Resource planning for the service orders , I am
getting the following message as "Planning board profile not found" -
Message Number : /MRSS/SGE031.
Any help or inputs are highly apprecaited.
Does any one has the MRS release config document for the
release 200.
Apprecaite your help.
Regards
Natrajan
is this issue is resolved? Or still facing the problem? pls lets work on it if its still open.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
I have no access to MRS currently.
Please check this link for PLanning Board Configuration. Please check your configuration maintained here.
http://help.sap.com/saphelp_dbm700/helpdata/en/be/d6a67384c0447f96e1a301146da35b/frameset.htm
Also check this thread. It may help you,
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
95 | |
11 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.