on 12-11-2012 7:48 PM
Hi,
In my opinion you have manual valuation active in sampling procedure. Please check it.
In MIC,use the control indicator "Sampling Procedure" active.
In Sampling Procedure use valuation mode as "Attributive inspection nonconf. units" instead of "Manual valuation".
Regards,
Alok Tiwari
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
The setting you have done is only confirmation not required, that means no need to confirm the operation in COR6 individually. The system does not consider this as a confirm able operation and does not give any message to you even though you miss to confirm this operation and proceed for the next.
The valuation popup displayed does not have any relation with the setting you are saying. That is purely a QM setting (may be in sampling procedure/MIC).
Revert back in case of any queries.
Regards,
Krishna Chandra
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
107 | |
12 | |
11 | |
6 | |
5 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.