Re-init activity

[erdem_sephanelioglu]

Hi all,

I have done re-init for 0sd_c03 cube

at the r3 side I deleted setup table and queue relevant. After finishing of setup tables I started delta init wo data and then full REPAIR. Upon data load I run v3 job however after a whıle I realızed at lbwe shows the job schedule is showing red light with NOT MAINTAINED.

Another Issue...I have unintentionally deleted ınıt ındıcatorr for 2lis_13_vdhdr 2lis_13_vditm and 2lis_13_vdkon without my will. Might that happen connected to some other activities I have done...

So what I have now is a full setup table from 05 March 2008 till 30 November 2013....

What would be my steps to catch the uptodate data ın 0sd_c03, covering delta from 30 nov till now....

Many thanks for those support this thread.

Eddy.

[Former Member]

Hi Eddy,

As you have data till Nov 2013(?) in setup table, you can reinitialize delta and then start delta load, you will get updated data in delta load.

Regards,

Ganesh