Skip to Content
0
Former Member
Nov 20, 2012 at 05:41 PM

Managed System configuration - Extractors Setup error

720 Views

Greetings,

Solution Manager 7.1 SP7. I am looking for help on how to track down this problem.

I have finished the Basic configuration and System preparation steps successfully. All remote agents are deployed and connected. The problem is when I run the Managed system configuration wizard for any of my systems, including the Solution Manager system itself, everything is green except for the "Extractors Setup" step in the "Configure Automatically" step. The same error occurs for all systems whether they are ABAP or JAVA. The log message is:

An exception with the type CX_SY_DYN_CALL_PARAM_NOT_FOUND occurred, but was neither handled locally, nor declared in a RAISING clause (1F09B73915F6B645E10000000A11447B)

Details:

An exception with the type CX_SY_DYN_CALL_PARAM_NOT_FOUND occurred, but was neither handled locally, nor declared in a RAISING clause (1F09B73915F6B645E10000000A11447B)
The following data was used for requesting extractors activation :
DB1/ABAP/0020593255 pv=01200314690900002540(SAP NETWEAVER 7.3) mi=1,01200314690800000134(Application Server ABAP) cv=01200314690200011948(PI_BASIS 7.30)
DB1/ABAP/0020593255 pv=01200314690900002540(SAP NETWEAVER 7.3) mi=1,01200314690800000134(Application Server ABAP) cv=01200314690200011846(SAP ABA 7.30)
DB1/ABAP/0020593255 pv=01200314690900002540(SAP NETWEAVER 7.3) mi=1,01200314690800000134(Application Server ABAP) cv=01200314690200011847(SAP BASIS 7.30)
DB1/ABAP/0020593255 pv=01200314690900002540(SAP NETWEAVER 7.3) mi=1,01200314690800000134(Applicatio.....

When I check the Extractor Framework, I see all the extractors for the Solution Manager system that are all green but none for the other managed systems.

I have another Solution Manager in our landscape and it does not have this problem even though all patches are the same.

I am looking for help on where to look to begin troubleshooting this properly. Specific questions that I have are:

1) What exactly is this step doing (Extractors setup)? Is it only setting up on the SolMan system or does it touch the managed system?

2) Where is the log physically located that the wizard displays (as shown above)?

3) I had quite a few infocubes that had to be manually activated in RSA1, could this be related?

Any insights would be greatly appreciated,