Skip to Content
avatar image
Former Member

Confirmation in " Error in transmission" status

Hi,

We are in SRM4.0, Confirmation status is showing as " Approved ". In BBP_PD we noticed that this confirmation status is in " Error in transmission".

We have checked all the IDocs in SRM and ECC. All the IDocs are posted successfully.

In ECC PO, the material document also created for this confirmation.

Is there any way to process this confirmation.

Thanks,

SU

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • Nov 15, 2012 at 11:56 AM

    Hi Suman,

    Please check the table

    BBP_DOCUMENT_TAB, where entries must be struck. Run clean_reqreq_up, entries should be cleared automatically if the idoc post in backend, if you still find the issue then clear the entry for that PO in document tab table mentioned above.

    Kind regards,

    Krish

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hi Krish,

      Thanks for yor quick reply.

      I have checked in BBP_DOCUMENT_TAB, we did't found any entries in this table.

      Clean_reqreq_up job is scheduled for every 30min.

      Thanks,

      Suman

  • avatar image
    Former Member
    Nov 15, 2012 at 03:45 PM

    Hi Suman,

    Please check Note #

    Note 1488981 - Confirmation remains in 'Error in transmission' status it refer the same issue which you are facing.

    Thank you

    Ritesh

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hi Ritesh,

      I have checked this not 1488981 and it is applicable for release 550 only.

      Thanks,

      Suman